Candy error e21

Candy error e21


  • How do you reset a Hoover dryer?
  • Find Out What Your Washing Machine Error Code Means
  • Hoover Candy Tumble Dryer Error Codes
  • Hoover DX C9TCEB-80 tumble dryer error code e21
  • Washing Machine Error Codes – Front Load and Top Load Washers
  • What do your tumble dryer error codes mean?
  • How do you reset a Hoover dryer?

    Such situations can be frustrating, especially if the laundry is needed that day. Thankfully, your washing machine is likely to indicate what the issue is, in the form of an error code which will flash up on the control panel. Hotpoint: F10 — no cold fill; check the taps to the inflow pipes are on and the drain hose is attached. F15 — water not being pumped out. Check the drainage hose is raised to its minimum height. F16 — extremely high water levels; turn off and disconnect the water supply.

    F17 — door not closed properly; check for any obstructions and remove as required. Disconnect the appliance from the mains for two minutes, reconnect to the mains and wait 30 seconds before turning the washing machine back on. LG: OE — an output error preventing the machine from being able to empty. Check the pump and filter for any blockages or damage.

    IE — an input error has been detected when the machine has tried to fill with water. Check for a kink in the hose, as well as obstructions to the valves inside the appliance.

    If the problem persists, check the control panel. FE — machine has overfilled; turn off the water supply and check the valves. Check the door is closed properly and the wiring is intact.

    E02 — the machine has failed to fill with water during its allocated time. Check the mains water pressure, by turning on the sink taps and checking for the usual pressure, if this is ok check the inlet hose for kinks, the pressure switch and inlet valve. E03 — the machine has not been able to drain in its allocated time. E04 — highlights an issue with the anti-flood and may also indicate a leak. Check the water inlet valve is locked open and the pressure switch is not defective.

    E08 — problem with the motor speed sensor; this can result in the motor spinning at very high speeds for a few seconds before slowing down and stopping. The fault may also prevent the motor from spinning at all. The likely cause is to be a blockage, and we recommend checking the filter and pump for any signs of debris or damage. Check the door lock and its connectors for signs of damage. If the error persists you may need to purchase a new control board.

    Check the resistance of the heater element using a multi-metre and if required, replace the element. Check the carbon brushes for wear and the electrical plug for damage. If the motor is spinning too high, check the tacho connection.

    The tacho connection is a coil which is fitted onto a motor to monitor the rotation and speed of the motor. If the problem persists, check the PCB. Knowing the various fault codes that may appear on your washing machine will help you keep your appliance running to its peak performance.

    Find Out What Your Washing Machine Error Code Means

    How do you clean the bottom filter on a tumble dryer? How do you reset a Hoover dryer? Many dryers are equipped with a reset button on the control panel. Then push the reset button. If there are no problems with the motor, switches, or electrical system, this should restart the dryer.

    Why does my Hoover dryer keep beeping? Hi, if it is beeping, it may qualify as the unit is telling you there is a problem. Usually this one will just need a professional cleaning to stop the beeping. When lint accumulates inside and can become a fire hazard, this one will beep that way. It is basically just a cleaning of excessive lint. Who makes Hoover tumble dryers? The Electrolux group own well over 50 brand names though not all of them washing machines Among the more well known ones are AEG, Tricity Bendix, Zanussi.

    The Candy group own Hoover, Zerowatt and Kelvinator among others. What does a 10 mean on a Hoover dryer? If this is not the chosen programe then simply swich the control to another programe selection. Why does my tumble dryer keep turning off? The dryer heats up and then will shut off.

    A gas dryer can get too hot if the vent is clogged and, eventually, this can damage the motor. Or the overload switch itself can go bad. What does E15 mean on a dryer? A safety notice has been issued for Hotpoint, Indesit, Swan, Proline and Creda tumble dryers manufactured between April and September due to a risk of fire caused by fluff coming into contact with the heating elements. How do you reset a candy tumble dryer?

    What does E21 mean on a candy tumble dryer? Step 1: Locate the Condenser. Step 2: Remove the Access Panel. Step 3: Remove the Condenser Door. Step 4: Pull out the Condenser. Step 5: Wash the Condenser. Step 6: Dry the Condenser. Step 7: Wipe off any remaining lint and put everything back together. What does E08 mean on a Hoover tumble dryer? Clean the filter and empty the water container after every drying cycle. Regularly clean the condenser.

    After each period of use, wipe the inside of the drum and leave the door open for a while to allow circulation of air to dry it. Why does my condenser tumble dryer smell? Tumble dryers can often suffer from musty smells and can quickly ruin, a fresh smelling clean load of laundry. Lint that becomes trapped in these vents can stay damp and hold the musty smell. As the dryer is running, the odour is pushed back into the laundry. If the load is too large, it may be taking too long to dry.

    Why does my condenser dryer take so long to dry? Drying times may be longer if the lint filter is clogged. The lint filter gathers fluff and fibres from clothes and needs to be cleaned after every drying cycle.

    A blocked filter drawer or condenser may cause longer drying times. These filters catch fluff and fibres that seep through the lint filter.

    Why does my candy condenser dryer keep stopping? Cleaning the filter is relatively simple but finding it might not be. What to do if Dryer keeps stopping? First unplug it for 5 minutes to allow it to reset. The thermal fuse helps to prevent a dryer fire by shutting off power to the dryer if it overheats. Test the thermal fuse with an ohm meter or continuity checker. Why is my new candy tumble dryer making a banging noise?

    A new tumble dryer making a banging noise after installation can be due to automatic transit bolts located on the drum that bump and bang the first time you use the appliance. This problem could also be caused by electrical installation which will need an investigation from a qualified appliance electrician.

    How do I clean the bottom filter on my Whirlpool dryer? Cleaning the Bottom Filter located at the bottom front of the dryer : Open the filter door on the bottom of the dryer and grasp the handle to pull out the filter.

    Remove the foam from the bottom filter. Clean the filter foam and the filter by hand or rinse with water — do not wash the filter foam in a washer. Simply wipe any lint away with a damp cloth or you can use a vacuum cleaner. If there is a lot of lint build-up you can wash the filter under running water in the reverse direction of the lint build-up.

    Make sure the filter is dry when you put it back into your tumble dryer.

    Hoover Candy Tumble Dryer Error Codes

    Hoover DX C9TCEB-80 tumble dryer error code e21

    IE — an input error has been detected when the machine has tried to fill with water. Check for a kink in the hose, as well as obstructions to the valves inside the appliance.

    If the problem persists, check the control panel. FE — machine has overfilled; turn off the water supply and check the valves. Check the door is closed properly and the wiring is intact. E02 — the machine has failed to fill with water during its allocated time. Check the mains water pressure, by turning on the sink taps and checking for the usual pressure, if this is ok check the inlet hose for kinks, the pressure switch and inlet valve. E03 — the machine has not been able to drain in its allocated time.

    E04 — highlights an issue with the anti-flood and may also indicate a leak. Check the water inlet valve is locked open and the pressure switch is not defective. E08 — problem with the motor speed sensor; this can result in the motor spinning at very high speeds for a few seconds before slowing down and stopping.

    The fault may also prevent the motor from spinning at all. The likely cause is to be a blockage, and we recommend checking the filter and pump for any signs of debris or damage.

    Check the door lock and its connectors for signs of damage. If the error persists you may need to purchase a new control board.

    Usually this one will just need a professional cleaning to stop the beeping. When lint accumulates inside and can become a fire hazard, this one will beep that way. It is basically just a cleaning of excessive lint.

    Who makes Hoover tumble dryers? The Electrolux group own well over 50 brand names though not all of them washing machines Among the more well known ones are AEG, Tricity Bendix, Zanussi. The Candy group own Hoover, Zerowatt and Kelvinator among others.

    Washing Machine Error Codes – Front Load and Top Load Washers

    What does a 10 mean on a Hoover dryer? If this is not the chosen programe then simply swich the control to another programe selection. Why does my tumble dryer keep turning off? The dryer heats up and then will shut off.

    What do your tumble dryer error codes mean?

    A gas dryer can get too hot if the vent is clogged and, eventually, this can damage the motor. Or the overload switch itself can go bad. What does E15 mean on a dryer? A safety notice has been issued for Hotpoint, Indesit, Swan, Proline and Creda tumble dryers manufactured between April and September due to a risk of fire caused by fluff coming into contact with the heating elements.

    How do you reset a candy tumble dryer? What does E21 mean on a candy tumble dryer? Step 1: Locate the Condenser. Step 2: Remove the Access Panel. Step 3: Remove the Condenser Door. Step 4: Pull out the Condenser. Step 5: Wash the Condenser. Step 6: Dry the Condenser. Step 7: Wipe off any remaining lint and put everything back together.

    What does E08 mean on a Hoover tumble dryer? Clean the filter and empty the water container after every drying cycle. Regularly clean the condenser. After each period of use, wipe the inside of the drum and leave the door open for a while to allow circulation of air to dry it. Why does my condenser tumble dryer smell?

    Tumble dryers can often suffer from musty smells and can quickly ruin, a fresh smelling clean load of laundry. Lint that becomes trapped in these vents can stay damp and hold the musty smell.


    thoughts on “Candy error e21

    1. In my opinion the theme is rather interesting. I suggest all to take part in discussion more actively.

    Leave a Reply

    Your email address will not be published. Required fields are marked *