How to start a lister diesel engine

How to start a lister diesel engine


  • The History of Lister Petter
  • Genrating Sets
  • 6.1 kW at 1500 rpm Lister Petter T Series Diesel Generator Engine – Air Cooled
  • 7.7 kVA Lister Powered Diesel Generator with Recoil & E-Start
  • 3.5 kVA Lister Petter Portable Generator with E-Start
  • Lister Petter engines and parts at factory-direct prices
  • The History of Lister Petter

    For example bore pumps where a dedicated line shaft pump is an expensive proposition when compared with an electric submersible. It features all the engine protection that is expected of a modern control panel monitoring Oil Pressure, Engine cooling temperature whether the engine is air or water, battery charge voltage and over speed.

    In addition to this the control panel monitors the voltage level both high and low, Hz or cycles of the alternator and the load being put on the set, if anything goes wrong the controller will pick it up. An additional important feature on the panel is the start delay contactor which allows the engine to start and settle into smooth operation before turning on the power to whatever is being driven.

    This also works in the reverse when the engine receives a stop signal the power is immediately switched off to the output and the engine allowed to settle back down before actually stopping. This feature is critical when powering electric motors controlled by electronic motor controllers which look for immediate accurate voltage.

    The generator control panel is also configured to read a pressure transducer which is supplied where required which can monitor the water pressure in the delivery line of a pump adding another level of protection to the system.

    If the pressure exceeds or drops below operator defined levels the controller will stop the engine to protect pipelines and pumps. The Generator Control Panel has three different methods in which it can start a generator set: Manual Start — Push the manual button then the Start Button Auto Timed — Starting in Auto mode a start and run time can be programmed to start daily or use 16 different start event times.

    Two wire start — close a no voltage two wire circuit to start the engine. Additional information.

    Genrating Sets

    Be sure to call us or visit our premises on the North Shore. Maintenance, repairs and rebuilds Our diesel engineers travel extensively throughout New Zealand and the Pacific, troubleshooting and maintaining Lister engines, and repairing and servicing where required. For you, that means proven reliability and workmanship, and confidence that the result will be the best it can be. Lister Petter in the UK were so confident and impressed with our abilities that they deliberately set up their regional office close to our workshop to enable them to call on Dave and his team for technical and service work.

    The rebuild dilemma A dilemma — should you opt for a rebuild of an existing engine or buy new? Boaties assisted with their design. Check out some of their great features: Compact footprint Fitted standard with a PRM hydraulic gearbox and flexible coupling for easy installation Direct fuel injection for instant starting Low fuel consumption Lister Petter swirl technology results in low emissions without the need for complicated electronic controls A cast iron water-cooled exhaust manifold with a water-injected exhaust bend keeps the engine bay noise and temperature down and makes it easy to connect into existing systems All genuine Lister filters and regular maintenance items are easily accessible and the engines come standard with a bronze sump pump for easy oil changes.

    Hydraulic tappets and self-bleeding injectors keep reliability up and maintenance costs down. Lister Parts We offer an extensive range of Lister parts and spares which can be sent to you anywhere in the world. Buying brand new Call us to discuss buying a new Lister diesel engine. Plus, we can export them anywhere in the world.

    6.1 kW at 1500 rpm Lister Petter T Series Diesel Generator Engine – Air Cooled

    7.7 kVA Lister Powered Diesel Generator with Recoil & E-Start

    For example bore pumps where a dedicated line shaft pump is an expensive proposition when compared with an electric submersible. It features all the engine protection that is expected of a modern control panel monitoring Oil Pressure, Engine cooling temperature whether the engine is air or water, battery charge voltage and over speed.

    In addition to this the control panel monitors the voltage level both high and low, Hz or cycles of the alternator and the load being put on the set, if anything goes wrong the controller will pick it up. The vehicle was constructed at the Park Road carriage works of Hill and Boll.

    3.5 kVA Lister Petter Portable Generator with E-Start

    It weighed 9 cwt kg including the lb 55 kg of the Petter engine with its flywheel and side bars. In Mr Robert Ashton Lister founded his new company to produce agricultural equipment.

    This included simple equipment like cream separators and other dairy and sheep shearing machinery, petrol, oil and gas engines, tractors, tractor ploughs and automatic electric lighting plants.

    This all started the process off to become what is now known as Lister Petter.

    Lister Petter engines and parts at factory-direct prices

    In recognition of his success as both a businessman and his time as a valued member of parliament, in he was given an honourable Knighthood for all his hard work and achievements.

    Inat the age of 84, Sir Robert Ashton Lister passed away. His legacy and products are still at the heart of Lister Petter in many ways. Maintenance, repairs and rebuilds Our diesel engineers travel extensively throughout New Zealand and the Pacific, troubleshooting and maintaining Lister engines, and repairing and servicing where required.

    For you, that means proven reliability and workmanship, and confidence that the result will be the best it can be. Lister Petter in the UK were so confident and impressed with our abilities that they deliberately set up their regional office close to our workshop to enable them to call on Dave and his team for technical and service work.


    thoughts on “How to start a lister diesel engine

    1. I think, that you are not right. I am assured. I can prove it. Write to me in PM, we will communicate.

    Leave a Reply

    Your email address will not be published. Required fields are marked *